Looks like a regular bulb and installs into your existing fixture.
Installation is easy-no tools needed and takes less than 1 minute.
Each bulb has 3 rows of LEDS lights!Plus ours is adjustable…
Available in 24” 28” and 30” $69.95 each
Installation:
1. Remove existing fluorescent bulb.
2. Remove starter.
3. Remove the protective pin caps from each end of the LED bulb (see figure1).
4. Adjust the black arrow to the 0 degree mark.
5. Hold each end of the LED bulb on the inner white ring (see figure 2) between your index finger and thumb and insert the pints into the fixture as you would with a fluorescent bulb. (please note the outer silver part of the bulb that has the black arrow turns for easy adjusting of the light angle afer you insert the bulb. By positioning the arrow to the 0 degree to begin with ensures both sets of pins are positioned the same. Holding the bulb by the inner white ring ensures you don’t accidentally turn the outer ring while inserting the bulb)
